Electrician PrecisionRichmond Hill electricians (289) 907-0816

EV charger installation in Richmond Hill

Level 2 home charging installed on its own circuit, in a garage, on an outside wall or in your condo’s parking level. We check the panel first, so the charger runs at full speed without tripping anything.

EV wall connector installed in a garage with the conduit run to the panel

Level 2 charging, done properly

A Level 2 charger runs on a 240-volt circuit and typically adds 30 to 60 km of range for every hour it charges, depending on the car and the circuit. That’s an overnight top-up for almost any daily drive in and around Richmond Hill.

The charger is the easy part. What matters is the circuit behind it: the wire size, the breaker, the run from the panel to where you park, and whether the panel has room for it at all. That’s where we start.

Chargers we install

Tesla Wall Connector, ChargePoint Home Flex, Grizzl-E, Emporia, Wallbox, FLO and most other hardwired or plug-in Level 2 units. Already bought one? We install it. Not sure which to get? We’ll tell you what your panel can support before you buy.

Grizzl-E Level 2 charger installed on its own circuit in a garage
Grizzl-E Level 2 charger installed on its own circuit in a garage
EV charger installed at an underground parking space
EV charger installed at an underground parking space

When the panel is already full

Plenty of Richmond Hill homes don’t have 40 or 50 spare amps sitting in the panel. There are three ways around it, and we’ll tell you which fits: set the charger to a lower current, add a load-management device that shares capacity with the house, or upgrade the service. The first two are often enough. The third makes sense if you’re also adding a heat pump or a second EV.

Condos and townhouses

Charging in a shared garage means working with the building. We coordinate with your property manager or condo board, follow the building’s requirements for the run to your space, and keep the paperwork the board needs on file.

What’s included

  • Panel capacity check and load calculation
  • A dedicated 240-volt circuit sized for your charger
  • Mounting and connection of the charger, plus app and Wi-Fi setup
  • Conduit on exposed runs in garages and outdoors
  • ESA notification and inspection

Questions about ev charger installation

How much power does a home charger need?

Most Level 2 chargers run on a 40- to 60-amp breaker. Many can be set lower if the panel is tight, which charges a bit slower but still fills most cars overnight.

Can the charger go outside?

Yes, as long as the charger is rated for outdoor use. We mount it where the cable reaches the charge port without stretching, with the run in conduit.

Do I need a permit?

Yes. A new 240-volt circuit is notifiable work in Ontario. We file it with ESA, and you get the certificate once it passes.

Can I use a plug-in charger on a 240-volt outlet?

Yes. We install a properly rated receptacle on its own circuit. Hardwiring is usually the better choice for daily charging, and some chargers only reach full speed when hardwired.

Need electricians in Richmond Hill?

Call or text with your address and what’s going on. A photo of the panel or the problem helps us show up with the right parts.

(289) 907-0816
CallText