Electrician PrecisionRichmond Hill electricians (289) 907-0816

Electricians in Richmond Hill

Panel and 200-amp service upgrades, EV chargers, pot lights, wiring and repairs for houses, condos and businesses across Richmond Hill. Every circuit labelled, every job tested before we leave.

  • Rated 4.9 on Google
  • Based at 10271 Yonge St
  • Residential and commercial
Open residential breaker panel with every breaker labelled
A panel replacement by our electricians, with every breaker labelled.
New service conductors landed on the main lugs during a 200-amp upgrade
New service conductors on the main lugs during a 200-amp upgrade.

Is your panel holding the house back?

A lot of Richmond Hill houses built before the 1990s still run on 60- or 100-amp service. That was plenty for the way people lived then. Add a heat pump, an EV charger, a hot tub, a basement suite or an induction range and the panel runs out of room fast.

Our electricians handle the whole upgrade, start to finish:

  • A load calculation, so you know what size service you actually need
  • New panel and breakers with a typed circuit directory
  • Mast, meter base or underground service work when the size goes up
  • ESA notification and inspection, and coordination with Alectra Utilities for the disconnect and reconnect

Panel upgrades in Richmond Hill

Grizzl-E Level 2 charger installed on its own circuit in a garage
A Grizzl-E charger on its own 240-volt circuit in a garage.

Charge at home, on a circuit built for it

Most EV owners in Richmond Hill do nearly all their charging in the garage or driveway on a Level 2 charger. Before anything is mounted, our electricians check that your panel can carry the load. Then we run a dedicated circuit to where you park and install the charger you bought: Tesla Wall Connector, ChargePoint, Grizzl-E, Emporia and others.

In condos and townhouse complexes, we work with your property manager on the run to your parking space and the paperwork the building needs.

EV charger installation

Contemporary kitchen with a stone island and recessed ceiling lighting
Recessed lighting over a stone island and the full kitchen run.

Lighting that’s laid out, not guessed

Pot lights look right when the spacing is planned: even light across the room, no dark corners, nothing crowding the cabinets. We mark the layout with you, cut clean openings and put each room or zone on its own dimmer.

In finished ceilings we fish the wires through the joists, so drywall patching stays small. Pendants, under-cabinet strips, sconces and soffit lights are part of the same job if you want them.

Pot light installation

Recent work

Every photo on this site is from a job completed by our electricians.

See all projects

How a job goes

  1. Call or text

    Tell us what’s going on and where you are. A photo of the problem or the panel label helps us come prepared.

  2. We look at it

    We book a time, see the job in person and explain your options before any work starts.

  3. We do the work

    Neat, labelled and organized, the way the photos on this site show. Permits are handled when the job needs one.

  4. We test it with you

    Every circuit we touch gets tested, and we walk you through what was done before we pack up.

Electricians who know Richmond Hill houses

Richmond Hill’s housing changes block by block, and so does the electrical work. Older homes around Yonge Street, Mill Pond and Richvale often still have 60- or 100-amp service, two-prong outlets and, in some houses built in the late 1960s and 70s, aluminum branch wiring.

Newer subdivisions in Oak Ridges, Jefferson and Westbrook usually need the opposite: finished basements, EV chargers and lighting upgrades. We’re based at 10271 Yonge St and take jobs in every part of the city.

Neighbourhoods we serve

  • Bayview Hill
  • Crosby
  • Devonsleigh
  • Doncrest
  • Elgin Mills
  • Harding
  • Headford
  • Jefferson
  • Lake Wilcox
  • Langstaff
  • Mill Pond
  • North Richvale
  • Oak Ridges
  • Observatory
  • Rouge Woods
  • South Richvale
  • Westbrook

What Richmond Hill customers say

4.9
Rated 4.9 on Google
  • ★★★★★
    “The absolute best in Richmond Hill. Scheduling was extremely easy, they were on time and had very fair timing! Great electricians.”
    W K Kwong, Google review
  • ★★★★★
    “Great service, the best guys in the business holy. straight 10/10”
    Jack Jamieson, Google review
  • ★★★★★
    “best electricians in richmond hill fixed my electricity all working good now!”
    Jotham winner, Google review
  • ★★★★★
    “Best electricians in Richmond hill! Would recommend”
    Rody Nunes, Google review
  • ★★★★★
    “Fair price here in Richmond”
    Abdi Bomber, Google review
  • ★★★★★
    “Great Service would recommend anyone”
    Jack Daniel, Google review

Read more reviews

Questions we get a lot

Do you handle permits and ESA inspections?

Yes. When a job needs it, the notification is filed with the Electrical Safety Authority and the work is inspected. You get the certificate once it passes, which is also the document your insurance company will ask for.

How soon can you come out?

It depends on the job and the week. Call or text and we’ll give you the earliest time we can actually be there, not a guess.

What should I send when I text?

Your address, a short description and a few photos: the problem itself, the panel with the door open, and the label on the inside of the panel door. That’s usually enough for us to know what we’re walking into.

Do you work in condos and townhouses?

Yes. We coordinate with your property manager or condo board on access, parking-level work and anything else the building requires.

Do you do commercial work?

Yes. Our electricians work in retail units, offices, clinics and plazas across Richmond Hill, from new circuits and lighting to panel work and tenant fit-outs.

Need electricians in Richmond Hill?

Call or text with your address and what’s going on. A photo of the panel or the problem helps us show up with the right parts.

(289) 907-0816
CallText