Electrician PrecisionRichmond Hill electricians (289) 907-0816

Electrical wiring in Richmond Hill

Rough-in for renovations, additions and basements, new circuits for big appliances, and rewiring for older homes. Organized, labelled and ready for inspection before the drywall goes up.

Open walls with the electrical rough-in done during a renovation

Renovations, additions and basements

Wiring is easiest to get right while the walls are open. We plan circuits around how you’ll use each room: enough outlets in the right places, dedicated circuits for the kitchen and laundry, smoke and CO alarms where the code wants them, and lights on the switches you expect.

Then we run it neatly, staple it properly and label it, so the inspection is straightforward and the drywall crew isn’t working around a mess.

Cables run neatly across ceiling joists during a rough-in
Cables run neatly across ceiling joists during a rough-in
Labelled cables entering an electrical box
Labelled cables entering an electrical box

Dedicated circuits

Big loads need their own circuit: electric ranges and cooktops, wall ovens, dryers, hot tubs, central air, heat pumps, EV chargers, and workshops or home offices with heavy equipment. We size the wire and breaker for the load and confirm the panel can carry it before anything is run.

Rewiring older homes

Houses with original wiring from the 1950s and 60s can have ungrounded circuits, overloaded runs and the occasional section of knob-and-tube. Aluminum branch wiring shows up in some homes built from the mid-1960s through the 1970s.

We can rewire a floor, a basement or the whole house in stages, and repair aluminum connections with approved methods where a full rewire isn’t needed.

What’s included

  • Circuit planning with you before rough-in
  • Neat, stapled and labelled runs
  • Smoke and CO alarms, plus AFCI and GFCI protection where required
  • ESA notification, rough-in inspection and final inspection
  • Device installation and testing once the walls are finished

Questions about wiring & rough-in

Do I need an inspection for basement wiring?

Yes. New wiring is notifiable work in Ontario. ESA inspects the rough-in before the walls are closed and again when the work is finished.

Can you rewire without tearing out all the walls?

Usually, yes. We fish new cable through existing walls and ceilings where we can, and open small access holes only where we have to.

Is aluminum wiring safe?

It can be, when the connections are done properly. The risk is at the terminations, so we repair those with approved connectors rather than leaving them as they are.

Do you work with general contractors?

Yes. We work alongside contractors and other trades on renovations and additions, and we keep to the project’s schedule.

Need electricians in Richmond Hill?

Call or text with your address and what’s going on. A photo of the panel or the problem helps us show up with the right parts.

(289) 907-0816
CallText