Electrician PrecisionRichmond Hill electricians (289) 907-0816

Panel upgrades in Richmond Hill

Replacing a full, worn or recalled panel, or moving the whole house from 60 or 100 amps to 200. Our electricians plan it with you, keep the outage as short as possible and leave every circuit labelled.

Wall-mounted load centre with conduit entering from below

When a panel upgrade makes sense

Most panels give warning signs long before they fail. In Richmond Hill we see the same handful over and over:

  • Breakers that trip when two appliances run at the same time
  • No empty spaces left, or tandem breakers squeezed in to make room
  • A 60- or 100-amp main on a house with central air, a finished basement or an EV
  • Federal Pioneer Stab-Lok and other older panels that home insurers question
  • Scorch marks, warm breakers, rust or a buzzing sound from the panel
  • An insurance company or home inspector asking for an upgrade

Panel replacement or a full service upgrade?

A panel replacement swaps the box and breakers but keeps your existing service size. It’s the right call when the panel itself is the problem: old, damaged, out of spaces or flagged by your insurer.

A service upgrade goes further. The main breaker, the service cable and often the meter base and mast are upsized, usually from 100 to 200 amps. That’s what you need when the house is asking for more power than the service can deliver. We do a load calculation first and tell you which one you actually need, so you don’t pay for 200 amps you won’t use.

New service conductors landed on the main lugs during a 200-amp upgrade
New service conductors landed on the main lugs during a 200-amp upgrade
Overhead service mast with new conductors run to the house
Overhead service mast with new conductors run to the house

What’s included

  • Load calculation and a clear quote before work starts
  • New panel and breakers, with AFCI and GFCI protection where the code requires it
  • Mast, meter base and service cable when the service size is going up
  • ESA notification, inspection and certificate
  • Coordination with Alectra Utilities for the disconnect and reconnect
  • A typed circuit directory inside the panel door

What to expect on the day

Power to the house is off while the panel is swapped, so we tell you ahead of time roughly how long you’ll be without it. Keep the fridge and freezer closed and they’ll be fine. When a service upgrade needs the utility, Alectra disconnects and reconnects the supply, and the work is inspected by ESA before everything is closed up.

Once it’s done, you get a panel with room to grow: spaces for an EV charger, a heat pump or a basement suite later, without starting over.

Questions about panel upgrades & replacement

How long does a panel upgrade take?

A straight panel replacement is usually a one-day job. A full service upgrade can take longer because it depends on the utility’s schedule for the disconnect and reconnect. We give you the timeline before we start.

Do I need 200 amps?

Not always. If the house has gas heat and no big electric loads, 100 amps can be enough with a new panel. Heat pumps, EV chargers, hot tubs, electric ranges and basement suites are what usually push a house to 200. The load calculation answers it.

Will my insurance company want proof?

Most do. You get the ESA certificate once the work passes inspection, and that’s the document insurers ask for.

Can you add a sub-panel instead?

Sometimes. A sub-panel adds spaces for a basement or garage, but it doesn’t add capacity. If the main service is already near its limit, a sub-panel just moves the problem.

Need electricians in Richmond Hill?

Call or text with your address and what’s going on. A photo of the panel or the problem helps us show up with the right parts.

(289) 907-0816
CallText